Hi all my tray is stuck in the machine any ideas other than brute force.

Well the trays can be somewhat difficult to remove on occasion, for me brute force gets it out. maybe a pic or two before you try brute force? Does the tray seem out of alignment or off in any way?

Intelligently applied brute force. [image] Tray stuck in printer Support & Troubleshooting Hi Owen, Have you seen this discussion ? It’s a similar issue to the one you’re having. The best way to avoid this situation is to keep the tank carrier and outside of the resin ta…

It moves slightly in the holder and is aligned, but won’t budge at all even with gentle force worried that too much force may cause issues

I had this issue and a rubber mallet on the back side of the tray finally released it. Start softly then gradually hit it harder. Of course, if you go too far you can damage the tray. But I wasn’t going to send it back in for that!

I’ve noticed that I sometimes forget to properly position the wiper blade when removing the tank. It’ll take me a good 30 seconds to realize it’s blocking it.

Tray is stuck in the machine

Support & Troubleshooting Form 1/1+

CraigBroady December 8, 2016, 7:41pm 3

Intelligently applied brute force.

Topic		Replies	Views
Tray stuck in printer Support & Troubleshooting	29	11156	September 23, 2017
Newbie question, difficulty removing resin tray Support & Troubleshooting	4	2819	July 13, 2016
Tray will not slide into printer Support & Troubleshooting	7	6076	July 9, 2014
Raising the resin tray Support & Troubleshooting	4	1959	January 7, 2014
Tray Stuck in Tilted Position During Print Support & Troubleshooting	12	5023	April 1, 2015

Tray is stuck in the machine

Related topics