The new firmware states it only supplies “various bug fixes”.
But there appears to be some other changes. There is a “skip” button during the resin heat-up stage in early printing.
I have not noticed anything else new.
You’d think there’d be release notes somewhere…
My 2 prints after updating the firmware showed an accurate time remaining widget on the display. Previously I was paying no attention to it since it was shamefully off, but these two times were actually spot on.
I had updated also to Preform to 3.10.2 and coincidentally those were my very first prints with Tough2000, I don’t know if that contributed too.
Oh, forgot to mention that one print was adaptive layer height (14h), and the other 100 micron (16h), both estimate widget were accurate.