Wiper parameter need adjustment!

I do not like the wiper because it makes a mess and occasionally damages a print. The reason is simple the platform is not high enough or timed too tightly to allow the wiper to do its job and get out of the way before the platform comes down. I witnessed this myself when it caused a big splash onto the cover right over the splash guards. It is especially problematic on ceramic as the material is so thick the wiper actually bends when trying to push through. Perhaps give us the ability to adjust it in Preform with a minimum, maximum (time to clear the platform) and frequency (ie… every layer or every 10).

This topic was automatically closed 7 days after the last reply. New replies are no longer allowed.