Silicone with Form 3 - problems

[Michele93]

Hi,

I am attempting my first prints (quite simple models) with Formlabs Silicone, but so far I have not managed to obtain a complete print. Typically, only the flat base is successfully printed, while the rest of the model does not form, even though the printing process continues until the end. I find the base stuck to the resin tank.

I am sharing a screenshot of the .form file as an example. Thanks in advance to anyone who can provide useful advice or suggestions!

[jessbuck]

@Michele93 Printing with Silicone Resin does have its nuances. To get started, have you checked out the two articles for printing with this resin? There are a few other resources available at the bottom of the page. If you still have issues, I suggest opening a support case so that we can dig in deeper and help with more detailed troubleshooting.

Using Silicone 40A Resin
Advanced tips for printing with Silicone 40A Resin