Self Cancelling Print?

Support & Troubleshooting
1

Last night I put on a print which was due to take 12h or so to complete. When I came back in this morning, only half the print has completed, and the form2 screen says the print was cancelled?

Has anyone had this happen before, or does anyone know why this might have happened?

One thought I had was that the resin tank is quite low, but there is definitely more than enough resin in the tray itself to complete the job. Even if it were running low, surely it should pause rather than cancel anyway?

2

If the resin were running low the print would just pause, not cancel. I have had it happen before. For my specific case, the power supply was not stable. I would upload your diagnostics and write a ticket to customer support. They can help figure out if there’s any issue or if there was some sort of power loss.

3

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.