Lumpy Tough Resin

I just bought a new Tough Resin cartridge and had problems getting it to fill up the resin tank. When I checked the resin, it became obvious that it was these jelly-like lumps were preventing the resin from flowing effectively.

Any one has this problem? How do I fix it?


Yikes, is this using a new tank and cartridge? I’ve never seen lumps like this in a new cartridge before so if that is the case, I’ll make sure to get you in touch with our support team so that we can look into this further.

Yes. It is new tank and new cartridge. The cartridge as 20161014 date stamped on it.

I’ve forwarded this to our support team and one of our members will be reaching out over email to help investigate further.

Thanks @Frew!

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.