Layer Separation Print Failure in Draft V2

[rauschjohn16]

Hey All!

My company just got a new 3L and I’m printing some large-scale parts in draft v2 resin at 200-micron layer height. The print failed in the middle and has a large gap (see picture.) Any idea what caused it? Should I angle the part for printing? Was it a support issue? Any advice for a new SLA user would be appreciated. Thanks!

[Jennifer_K]

Hello @rauschjohn16,

Thank you for the picture of your issue. I would reach out to Support to have someone troubleshoot this issue to make sure we identify the right cause.

Regards,
-Jen