Wash 3L - Is there a Fill line?


I have a Form 3L / Wash L / Cure L that we are just getting setup here at my workplace.

We selected TPM and received several big jugs of that recently.

In looking over the documentation, which is largely very good, doesn’t quite say how high to fill it to (maybe we missed that being super cautious!).


Hi LePaul! There should be a black horizontal line in the back of the wash bucket. If not, just fill to ~1.5 in from top below the flap closures. You can can also set this visually with a lowered Build Platform in the Wash L. Hope this helps!

Found it! Ok!

We were a bit surprised that wasn’t highlighted in the web docs.

I’m seeing some posts about the pump not having a long life span. What would be an improvement?