Red Resin?

[Paul_Schommer]

@Gary_Cairns thread, mentioned above, for those too lazy to search:

MakerJuice resin vs formlabs

Morning all. I decided to carry out a comparison between the makerjuice and formlabs resins. I wanted to carry out a proper stress test and so I picked out the following engine block model. This model is a good one as it has several flat surfaces, several curves of varying degrees, thin walls, holes and text. I printed it at a 50% size (just to fit it in the printer) and printed at 100micron layer thickness. I printed the formlabs using the black setting and the makerjuice on the grey set…