Print quality

Support & Troubleshooting
1

I would like to know from formlbas or thoses who already have the printer if there is a print area .

What i mean by that : if we have better quality if we put the model in the center of the printer , and leave the maximum as possible the corner . I suppose the laser will go easier in the center than the edge of the build volume.

Because i will have a lot of prints to do at the same time, and i need to know if the quality will be the same all over the print area or not.

2

Hi Gilles-alexandre,

The build area of the Form 1 is 125 mm x 125 mm in the base and 165 mm tall.  You should not notice any difference in accuracy or part quality at the corners of the build area versus the center of the build area.

Cheers,