Preform 1.4 Level the vat for resin top ups

With the new firmware and peel cycle for pre form 1.4, when a job is paused for a resin top up, the vat stops in the down position.

When the job resumes, the vat lifts resin can be seen to flow towards the hinge side at a fair speed and the print resumes when the resin is still visibly flowing across the vat. The resin never seems to move at this speed at any other time.

This leaves a visible line across the printed part at the point of the top up.

When the job is resumed, it would be nice if the vat moved up to position for the next layer and then paused for say another 20 - 30 seconds to let the resin flow settle down.

Hope this makes sense.

Paul