The printing stopped with the message “motors jammed
” …
I did not find anything that prevented me from going down the print board. I could continue without problem.
question: do you have to grease the worm and the rail from time to time?
Is there a test function on the rise / fall of the tray at the end of the test?
This might help (or not):
I presume you’re referring to the ‘motors jammed’ error and this is designed to detect when a part of a print is stuck in the tank. Generally, this gets thrown when the wiper or another motor doesn’t return to its home position in the amount of time the printer would expect. Excessive peel force can cause this as well but it tends to be fairly noticeable when the tank is struggling to peel.
I’ve seen this thrown by mistake a few times and if you checked the tank and didn’t seen anything, you sh…
Can anyone tell me if it is necessary to grease time and time the worm and the guide rail of the tray?
Thanks
1 Like
system
Closed
October 18, 2019, 3:10pm
4
This topic was automatically closed 7 days after the last reply. New replies are no longer allowed.