Kann der Tank eigentlich überlaufen?

Hi,

I’m getting the same problem - I see that the tank is filled with much more resin than needed and have concerns that can overflow. After some investigation I found that the firmware is not taking in account the temperature of the resin and like result there are two bad effects:

  • when adding the resin it takes longer for the float sensor to become asserted (up) which in turn makes the printer to add excessive resin (much more than needed)
  • sometimes the printer can report that the resin cartridge is empty or clogged

Especially in the winter, if the office temperature drops when you leave the office, you may experience (like me) some weird printer behaviour during the first print next morning - printer adds more resin than needed or reports there is no resin in cartridge. Once the printer was heated - everything works well.

Maybe the solution is the firmware to first heat the printer and then to continue with poring the resin.