Height of Optics Test Pylons

Support & Troubleshooting Form 2
1

I have a suspicion that my Z height needs to be adjusted. My number 1s on the optics test are a little short. And when I occasionally print something flat on the platform itself, the material on the base is somewhat shorter than it ought to be. So I’m curious, what is the nominal height of the optics test pylons? Would they come out any taller if my Z height is currently set too far low and I set it higher?

Thanks,
Alex

2

Hi @StarFlicker,

Thanks for getting in touch! Although I don’t know the exact height of the optics test pieces, adjusting your printer’s Z-height offset would compensate for the overcompression you noticed.