Has anyone experienced the sudden death of a Form Cure? After using the Form Cure about 25 times there is no display, no LED’s, but the table rotates constantly. When plugging in the power cord on the rear of the unit, after a 5 min. unplugged time for reset, there is a small spark that leaps out of the female jack.
After an email to tech support it’s clear that there is now no 3V3 LED on the PCB, visible through the vent holes on the bottom of the machine. Unfortunately, I now I have a $700 gigantic paper weight as FormLabs does not repair or provide parts. I’m hoping someone out there has found a solution.