Here is an STL for anyone wanting to use a 4inch (100mm) ventilation hose on the back of the Form 4 to evacuate odor. I use a 4 inch hose to a carbon/HEPA combo extractor that helps significantly reduce odors coming from strong resins like Tough 1500 and 2000. I printed this in PETG on my PrusaMini+, 15% infil with supports. Use a zip tie (cable tie) to secure the hose to the indented rib.
form4_to_4inch_Hose.stl (5.1 MB)
are you guys running these on your desk in a office because we never smell anything unless we get close to the tank or after the cure?
I have a very small studio in my basement, and the odor is noticeable with the Tough resins. I smell nothing when printing Black V5, so don’t need to run anything for odor. There is a ‘cooked’ odor with Tough2000 after curing/baking for an hour
Very nice, thank you very much for sharing !
Is there any chance you could share the source file so we can adapt it to our output diameters?
here’s the formlabs page with all the printable parts for all their printers.
This topic was automatically closed 182 days after the last reply. New replies are no longer allowed.