Hello,
My form 3 L has been shifting on the y axis. It will print the raft then slowly move back each layer.
I have a print that works fine then the next one will do this. I am updating firmware next. Does anyone have any suggestions?
Elastic 50A resin.
Thank you!
Amanda
Hello @aybehr,
Thank you for reaching out about this issue with drifting parts on the Y axis; on the Form 3L, this is an issue we saw that has been remedied by updating to firmware version 1.6.6 or later. If the issue persists past that, then please open a Support Ticket and include photos and any other relevant information and we can ensure that this issue is resolved.
This topic was automatically closed 182 days after the last reply. New replies are no longer allowed.
