Form 3 teardown


#1

For anyone who was surprised there was no teardown done by bunniestudios when the form 3 was released…

It just popped up in my feed!

https://www.bunniestudios.com/blog/?p=5701


#2

Hey did Andrew forget to remove the LPU shipping latch? Yet the LPU is moving?

On the right hand side, there’s a blue anodized latching mechanism. I’m not sure what it’s for – my Form 3 arrived in a special shipping case, but perhaps on consumer units it’s meant to secure the LPU during shipping

https://bunniefoo.com/form3/form3_lpu_insitu.jpg

https://bunniefoo.com/form3/form3-lpu-inside.jpg

https://support.formlabs.com/s/article/Setting-Up-Your-Form-3

Also, don’t tell me it’s coincidence bunnie got a printer named CorrectHare.