Form 2 using third party resin

General Discussion
1

Hello,

Any owners of a Formlabs Form 2 using third party resins?

I have a Form 2 and given that Formlabs is, or has, discontinued selling resin for this printer, I need to start using a third party resin, like Sunlu, AnyCubic, etc. actually I would prefer using third party resin due to the low cost.

I did try AnyCubic initially but ran into problems with it. Recently I tried Sunlu water washable resin but I’ve encountered failures with it as well. At first I used a used, but cleaned, resin tank, and warm up the printer, and resin. Prints failed. I then opened a brand new resin tank but I still got failures. The printer works great when printing with Formlabs resin, which I don’t have much left of.

At this point I’m not sure what to do, other than trash the printer and save for a new Form 4.

Any suggestions?

Thanks!

2

I have has success with Creality ABS like on my form 4. You can read about it here. Open material mode - #18 by leonhart88