Delay print start (or set target print end time)

[alarictaylor]

Hi,

We often would rather start the printing of a job after a delay than print a job and leave it hanging in the printer for hours/days before anyone has the chance to unload it.

Would it be possible to schedule a print to start/end at a specific time? I realise this could be a little complicated if you have to factor-in warm-up time…

Thanks,

Alaric

[OliverK]

Excellent idea!

Not a fan of going into the office at 3:00 in the morning to clean up a print! The timing doesn’t have to be extremely accurate; an ETA that’s a within half an hour would be fine… just so prints finish during office hours.