sorry cant remember the original poster
Me!
I’m sure there’s a market for a “commercially available” curing box. But you can make the one I “designed” for about $50. It works good. it’s as large as the print volume of both the Form1 and Form2, It’s 20 or 24W of UV so it also warms the print while curing it, the LEDs are on the outside of a plastic/glass container so you can fill the container with water to cure anaerobically, and they’re low voltage LEDs so if you spill water you’re chances of electrocution are minimal.
This part, photographed inside the curing jar, is about 160mm in diameter.
