Advice for Form 2


#1

Hello everyone,

I bought a Form 2 with the LT tanks, and black, gray and draft resin that will arrive to me this month, but I have seen here in the forum that there are problems when updating the firmware and with the software for Windows 10. Can you give me Some tips please for when I start it for the first time.

Thanks and a good day.


#2

just plug the printer into your computer with a USB cable rather than trying to update over wifi.


#3

Unless there is some recent issue that cropped up since I last updated…


#4

Ok, i will do that. Thanks for the advice.


#5

This topic was automatically closed 7 days after the last reply. New replies are no longer allowed.