Tough 1500 V2 prints

[Friedl_1977]

Hi @Sophia_M

thank you for the feedback.

@Sophia_M

Please feel free to open a support case for this issue, so that our team can investigate the problem directly,

I have done this…. and the problem was never resolved unfortunately. Here is a link to another post in 2024 already. As you can see, the same layer lines on the flat part of this model appeared.

Here are more:

Best orientation for dimensional accuracy?

Hi - I had to print some parts in Black today, so I used standard V5 BLACK resin. I initially when it came off the build platform eventing look quite nice but after I removed the supports I could clearly see some layer lines that are quite prominent. Is this to be expected? Would it help to print on 50µ ? I then tried some sanding with 1000 grit paper and applied some oil as suggested in many forums, but this removes the mat black finish. After curing and finishing: [5A6A9175-935E-45D4-9…

Best orientation for dimensional accuracy?

Hi - Some more disappointing results; [IMG_1302] Settings: Standard Grey V5 50µm 100% supports autogenerated touch points 0.45 Washed for 20mins on High Cured for 10mins at 60C Really hoping Support can chime in here. Regards, Friedl.

There are more cases as I was each tome advised to open a support ticket which I did, but the problem was never really solved.

My apologies, I do not mean to come across rude… just a little frustrated as it feels the problem is just being moved from one department to another until such time that I stop asking.