I have a form 2 that has less than 10 prints total on it.
I am just noticed this really strange over compression-like issue with my square prints.
I am using an LT tank brand new build platform and v2 draft resin at 0.2mm layer height.
I am wondering if I can calibrate this out or if the cause more deeply rooted. Any help would be greatly appreciated.
Image 1
https://share.icloud.com/photos/0359BZDLGm6-uBOJO_VvUZVqA
Image 2
https://share.icloud.com/photos/027Q-pP30EzbMKAne2K7fbtTw#Temecula_-_Sycamore_Creek
Image 3
https://share.icloud.com/photos/0ndTACxO9pM0N2lFsm0lB__PA#Temecula_-_Sycamore_Creek