For anyone wondering about a resolution to this post I found the following thread and purchased the heated fan and then 3d printed the clip with my FDM printer:
Living in Minnesota, there are many months of the year where my workroom is barely above 60 degrees F in the morning, and doesn’t get above 67 at any point in the day. The print success rate always drops for me when the temps drop, even if I prewarm the resin. After several failures, I finally found a great solution for maintaing a constant temp in the printing chamber, and it’s been working very well for several months now this winter.
The product I bought and adapted for my Form1 is a small…
Here’s a good video on fine tuning the form 1+:
Here’s some good equipment:
1 Like