PoisedWhale reporting for duty

[Ante_Vukorepa]

Interesting! That’s quite a different result than the caliper photos here seen here (which IIRC is off by 3-10%)

That’s white resin, though.
For what it’s worth, i’ve had overcuring issues, filled up holes, etc. with white on Form2 as well:

White resin overcuring

Has anyone experienced odd overcuring issues with the white resin? It was fine three prints ago, now suddenly, negative features are ending up very noticably overcured. For example, a 1mm dia hole oriented about 45 degrees to the tank plane, is ending up as an indent rather than a through hole. The only thing that changed in between prints is that the parts that appear overcured are very near the farthest extreme of the tank from the peel pivot. I’m also using almost the whole volume of the F…

In case it’s at all helpful to you, here’s the very first part I designed and printed on my Form 1, ShaftTest.zip

Thanks, will give it a spin!