It’s been about 6 months since I did a print on my FORM3. I powered it on and it automatically found a firmware update and loaded without me connecting my laptop to the wired port.
Also it lets me print past jobs without loading again via preform. Was wondering if I should make a new job with updated preform just in case it improves something from that saved print job.
Hello @bitsyncmaster,
This is a good question on past jobs that are stored on the printer. These jobs aren’t updated for new settings in Preform, so I would reupload the jobs to take advantage of new settings - you can use the queue to delete the old jobs, as well.
Regards,
-Jen
This topic was automatically closed 182 days after the last reply. New replies are no longer allowed.