Since heating the resin takes quite a bit of time, it would be great if i could fire up a pre-heat cycle manually, while i set up the print in PreForm, so it’s ready to go when i’m ready to send it to the printer.
Would save quite a bit of time.
Since heating the resin takes quite a bit of time, it would be great if i could fire up a pre-heat cycle manually, while i set up the print in PreForm, so it’s ready to go when i’m ready to send it to the printer.
Would save quite a bit of time.
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.