Losing Power

So in the middle of the night ,at the end of a print, the power went out. It only needed a few more layers to print a few LT clear nightgaurds. An error message popped up, I didn’t see a continue button, only a dismiss button, and then it went to the home screen. They were all ruined because I could not continue were the print left off. Is there a way to continue a print when the power goes out?

Only if you have a UPS… I’ve used this one.

UPS is invaluable. We get lots of power interruptions where I live, I would have lost dozens of prints without my ups.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.