LED Cure oven

I took an old Glidewell Zirconia drying unit out of storage and made an LED light cure unit for our printed models
we have 100W of led’s that run at 400-410nm (our printer runs at 405nm)

the led’s are on magnetic rails so they can be moved around (if adding a second shelf)

the glass will also sit on magnetic rails (shelving 16x11 in, up to 2 shelves)

features minimal heat with a fan… can add a fan controller to maintain a set temp 110 degrees (65.00)
power switch and 2 dimmable meanwell drivers
upgradeable to internet connectivity (200.00)
cure time on testing is about 2 minutes, but I’m guessing 10 for full models
pic shown is on low, but it will need to run at 40% to reach 405nm optimum

total cost 450.00 +/-

4 Likes

update: 20 minute cure time on white resin, and a 30+ min cure time on grey