Failed print on tall overhangs - Tough

I am trying to print some large parts in tough, I have tried a single part and both. They fail when there is an overhang and it doesn’t bridge and then sticks to the tank. This is the first LT tank that I have used. Tough resin, 2 months old, mix every time.
Going to strain the resin (didn’t see any bits, but covering all bases) and try one part as low of a tilt as i can in the build ar


Any ideas what is causing this. 3 try on tall parts, no joy.

This topic was automatically closed 7 days after the last reply. New replies are no longer allowed.