Cure time under UV lamp

I read that you should cure your object for 60min on the "energy’ page of the manual. I only have a 30mm miniature and I have been leaving them for only 10min usually. Should I leave them for longer, less?

He’s still a WIP, prototype for Dwarves of Iron Peak board game

It’s probably best that you leave it for the time specified. While printing, not all of the photo-polymerization reactions occur. UV curing completes any unfinished reactions and finalizes the material properties. You’ll notice that parts in standard resin become harder after being fully UV cured.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.