Has anybody had a problem like this? I know that the tank usually requires a bit of force to take in and out of the machine, but I’ve been printing with the same tank in the machine for about 2 weeks now, and I finally went to remove the tank and it seems stuck. It will slide forward about 1/8" an…

Hey… We’re having the same problem here… The resin tank doesn’t slide out of the machine… Any news on this subject? It is a new printer…the problem is that we made a test print and left the tank there…now… it doesn’t come out! Help!!!

It turned out that one of my detents was stuck. I was able to remove the resin tank out of the machine by lightly tapping on the tank from the backside of the machine (I used a small mallet with some folded towels on it for padding). I informed formlabs about the stuck detent and they took care of…

I’m having the same issue here. Stuck resin tank… I’m reviving because this might be a semi-common issue. It’s the same right side.

This happened to me too literally minutes ago. After a failed print, my resin tank does not level anymore and i cannot remove it cause it’s tilted to the right. I tried turning it off and on again, but apparently it won’t move an inch. I submitted a ticket, hope i get a fast response.[image]

It happened to me too. Same problem as JoeKuhn reported. The tank seems to be fixed to the seat. The left side (seen from front is sligthly movable. The right side however sits like clued. Anyone of the guys that had reported such an issue before found a solution? Help of formlabs support is ap…

Hey @Mario_Huettenhofer ! Feel free to [send in a ticket][1] and we’ll be able to help you out. :slight_smile: [1]: http://formlabs.com/support/troubleshooting/submitting-a-ticket/

Exact same problem here. Could someone please post the solution? It’s Saturday, don’t have time to submit a ticket/pics and wait til Monday. Thanks!

Mine is stuck as well just as Burde_Alexandru_Vict picture shows and right after a failed print. As a note, In many of these threads I see there is no solution offered, the thread just stops without being solved. Can someone please reply what they did to resolve it before closing the thread? I do…

I have had both described issues happen. The route cause of both was probably the same, that being chipped corner on the tank. In the case of the tilted tank, my peel motor stopped working. Formlabs sent me a replacement that was easy to install, I believe the cause was resin that had overflowed …

Resin Tank Stuck in Printer?

Support & Troubleshooting

John_Ormond June 14, 2015, 12:21am 12

Problem for me is the ball plunger is stuck in the out position, as detailed here: Tray will not slide into printer. This seems to be a common problem

Topic		Replies	Views
Stuck in "peel" can't remove resin tank Form 1/1+	1	2731	July 18, 2018
Can't remove the resin-tank out Support & Troubleshooting	4	3055	October 29, 2014
Tray stuck in printer Support & Troubleshooting	29	11156	September 23, 2017
I have a critical issue with Form+1 printer Form 1/1+	28	5506	July 3, 2018
Tray Stuck in Tilted Position During Print Support & Troubleshooting	12	5023	April 1, 2015

Resin Tank Stuck in Printer?

Related topics