On some prints with the Form 2 we are getting striations on the surface that seem to be a many layers thick and large enough to feel. They start at the edge of a feature on the part and then continue across the remaining width. I’ve included a couple close up pictures to show what I’m talking abou…

Hello there @aeroscarr13 ! This is a terrific question, and a situation that we’ve seen a few times! The cause is actually pretty simple. It’s an odd characteristic of PreForm that, if you have zero-thickness gaps between two parts of a model, these lines will extend out across the entirety of the …

Thanks for this. This has been bothering me also for some time now. I thought it was a problem with resin tank and layers not peeling off correctly.

Dank: It’s an odd characteristic Nicely said :stuck_out_tongue:

Print Striations/Ridges

Support & Troubleshooting Form 2

Topic		Replies	Views
Striations in flexible molds how to reduce or remove Form 2	7	2223	August 15, 2017
Lines in recesses and on flats? Form 2	14	2179	December 15, 2018
Small streaks/lines printing onto a supposed flat surface...any ideas? Support & Troubleshooting	4	2729	August 6, 2015
Striations appearing in prints, grey V3 resin Form 2	7	2823	May 25, 2017
Print has ridges that are not found on the original file Form 2	7	3778	October 18, 2017

Print Striations/Ridges

Related topics