Viewable XYZ Axis?

[ChristopherBarr]

@Randy_Cohen

Hmmm. There must be something very different about the workflow you guys employ and the one I use. I have never scaled anything in PreForm.

Then your prints are simply not accurate. To make them dimensionally correct, a combination of fine tuning x&y plus total part scaling is required.

see my post with gauge objects and calculator here:

Dimensional inaccuracy

Dimensional inaccuracy We are currently using this printer to make dental models that we then use to fabricate ortho retainers on. I have been printing very successfully for the last 2 weeks and not really run into any issues to speak of. However, after doing some checks it seems that the prints we have are slightly bigger at the base than the original plaster cast model we make. Its not huge, probably less than 0.5mm but ideally this should be zero. What is the process for using the adjustme…