With the module shown…
- Did you do any finishing to the cavity surfaces? Or is the part shown, raw SLA transfer.
- I don’t see any hints of venting in the screen capture, or the actual tool (it could be on the other side, but between both images, I belive you show both). not a worry?
- Did you use ejectors? Or was it a hand pickout?
- How did the insert fit? DID you go line-to-line, or use a surface offset?
- Did you grind/treat the parting line/plane… or is it as printed?
… feel free to not answer some or all questions, I’ll take no offense.