I’ve had pretty good luck with the V2 Grey but the cost when doing production would be nice if lower. Not sure this other resin is the answer but seeing I have a tray to use I might as well give it a try.
I only use the Grey as our parts get painted afterwards anyway.
Fine detail is important but I’ve been doing some custom work for a fellow who has printed at Shapeways and he says mine is better. [grin] There was warping and such with the Shapeways prints but not the Form2. All the detail was there as well. Only real issue is support points. I’m down to .050" supports. If I go any lower they snap during the printing.