Hi, I got my form 1+ after replacement in November end. I am using castable resin with my new form 1 +. But having casting problems with its casting. Does anyone having same problem with material. posting pics of my casting and printouts could anyone suggest what wrong am i doing ? here is dropbox…

i try company http://zpcasting.com/ Zero Porosity casting, they did good job on my casting from castable formlab1+ blue resin.

Hi, what investment powder are you using?

I send wax (blue castable resin ) to company zpcasting.com

I used to have the same problem but eliminated them by setting up an initial burn of 290 degrees for four hours. At this temperature even using regular satincast I have no problems any longer and the castings look great. it seems that above 300 degrees the resin expands. The plaster investment mu…

Has anyone found a solution to the removing the striations/layer lines on the castable resin models? @mikhailburyakov ’s ring looks amazing, but the striations are distracting and it looks impossible to hand finish I am just wondering if there is perhaps a (gentle? small particle?) vibratory tumbli…

I encountered the same problem, Surface is very rough, but I can not solve this problem. @bhrugesh_virani

best thing to solve problem is curing it with UV curing box for at least 4 hrs. or till it doesn’t remain sticky. you must perfectly maintain burnout cycle as it would not be possible to get better surface in wax burnout cycle. resin burnout cycle is given by formlabs. you must follow it very accu…

Well I used plasticast investment cured my rings for 4 hours. I degassed my investment in the flask and also vibrated out the bubles. I didn’t have a digital scale so that may be my problem. I may have ratiod the investment a little too wet. I followed the burnout procedure with a 5 degree celcius a…

not to worry if using plasticast. srs cad cast or same investment. also investment used for platinum will do or steel , i mean higher temperature metal investment powder. initial burnout is important as resin tend to expand if temperature rise faster, so if furnace not accurate could create problem.…

Castable resin casting problems. does anyone getting this?

Support & Troubleshooting

mikhailburyakov February 18, 2015, 4:18pm 22

Curing and Casting castable resin

Topic		Replies	Views
Curing and Casting castable resin Support & Troubleshooting	20	14844	December 11, 2015
Casting jewellery Projects & Prints	343	63752	December 2, 2020
Purple resin castable General Discussion	39	9674	April 10, 2020
Print and Cast with FireCast resin Projects & Prints	23	13063	September 9, 2014
Issues casting prints Projects & Prints	26	11747	February 1, 2017

Castable resin casting problems. does anyone getting this?

Related topics