Pre-Washing Whole Build Trays - What's Your Setup?

Hey Everyone,

Reading through the Form Wash info on the Formlabs site I found this little nugget:

To significantly prolong the lifetime of the alcohol before replacement, consider implementing a preliminary rinse with a small volume of alcohol before inserting printed parts in Form Wash.

I’m planning to integrate a pre-wash step after my next Wash IPA swap, and am curious what others may be doing for this. (outside of sloshing around an upside down build tray in a bucket for a few minutes) Any cool hardware or equipment people found helpful?

Thanks in advance, I’m stoked to get a little creative with this!

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.