March 18th firmware added preheat before mixing with real time temp monitoring
Discovered by chance… the firmware release notes are indeed terse…
But this is again good news!
Yes, I too noticed that change and was psyched to try it out. Except my machine, in an ambient of about 63ºF, cannot achieve the 33ºC starting temp required by Tough2000. I have to “preheat” my workshop for 30 minutes before attempting a print. And then, if I don’t want to wait another 30 minutes for the Form3 to heat the resin up, I have to put a cover over the machine.
My machine’s heater may not be working correctly.
It probably isn’t based on how my machine is able to preheat successfully in cold environments. 