Calibrating models for the Form1+

[JoshK]

I made this for that purpose. Be sure to imagine it as one huge block.

Print Better by Discovering your Form1+ Advanced Calibrations

You can get better prints by knowing about the errors in your Form1+. You can even print this at the same time as other models so you don’t have to do a special run. And if you post your results, we can discover what is typical is too. I made this test file for the community and just printed it: https://www.dropbox.com/s/qbbuyuo4oxdqepv/Form1%2B%20Scale%20Test.form?dl=1 (Form1+ Scale Test.form) And then measured it with a digital caliper. And from the various measurements I was able to dis…