Hi @billb, thanks for joining in the discussion.
Just a couple of quick points:
- All of my ring designs print in the same vertical orientation on my Form 2 without problem.
- Increasing the number of touchpoints has no effect on this kind of overcuring, which seems to have been eliminated for other resins through changes to the Preform software and/or firmware updates.
- These touchpoints are the new, super-small ‘light-touch supports’ especially created for Castable Wax resin.
- If you’re interested in the analysis of this problem to-date, take a look at @lmlloyd and @larsenstephen posts on the following thread: Bad prints out of brand New Form 3