# Trying to add vibrator at fuse1+ material hopper for CF material

**URL:** <https://forum.formlabs.com/t/trying-to-add-vibrator-at-fuse1-material-hopper-for-cf-material/44415>\
**Category:** Fuse 1/1+\
**Created:** [May 13, 2025, 8:29pm UTC](https://forum.formlabs.com/t/trying-to-add-vibrator-at-fuse1-material-hopper-for-cf-material/44415 "2025-05-13T20:29:52Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![chengsam2000](https://avatars.discourse-cdn.com/v4/letter/c/bb73d2/32.png) [@chengsam2000](https://forum.formlabs.com/u/chengsam2000)\
**Post date:** [May 13, 2025, 8:29pm UTC](https://forum.formlabs.com/t/trying-to-add-vibrator-at-fuse1-material-hopper-for-cf-material/44415/1 "2025-05-13T20:29:52Z")

</div>

the experimental vibrator setup if you would skip the long story

[![](https://img.youtube.com/vi/iWgu3SZu6Qs/maxresdefault.jpg "Vibrator test") ](https://www.youtube.com/watch?v=iWgu3SZu6Qs)

the fuse1+ can work with nylon11CF is a good combo and can provide more attractive product than just regular pa11 / 12  
but just as the official document stated, the CF material is REALLY~~~ clug friendly

it is not about new/ old powder ratial, wet or not  
it just like to clug

ruined 3~4 of mine print job, especially if you try to stir the powder  
no matter i only pull one small cup a time of powder, or i pull a lot at a time  
as long as you stir the podwer, clug guranted

so far, i can only print with one cartridge a time, and only fill when lower than 1L  
which is definately not ideal for production run

now the vibrator i hope can solve the issue, video at top  
it is a 12V vibrator been wrap inside a rubbeer glove for protection, and the glove itself have a rubber band to secure on machine to prevent whole setup slip into the feed system  
since i forget to have timer, i now run it 3 second every hour  
the material as see at video, it original have 2 big feed cone , print will most likely to fail if all other material won’t collapse and fill the gap  
nw after vibrator, it seems help

still under running test at this moment

i will report more after extensive test

it ideally best screw on the hopper but it will definitely ruin the warrenty, so that is why i choose this funky setup

---

<div class="post-metadata">

**Author:** ![chengsam2000](https://avatars.discourse-cdn.com/v4/letter/c/bb73d2/32.png) [@chengsam2000](https://forum.formlabs.com/u/chengsam2000)\
**Post date:** [May 13, 2025, 9:24pm UTC](https://forum.formlabs.com/t/trying-to-add-vibrator-at-fuse1-material-hopper-for-cf-material/44415/2 "2025-05-13T21:24:40Z")

</div>

working video

[![](https://img.youtube.com/vi/I8vceNfOp0A/hqdefault.jpg "Vibrator working") ](https://www.youtube.com/watch?v=I8vceNfOp0A)
