# Super easy way to make a DIY curing device with UV light and heat

**URL:** <https://forum.formlabs.com/t/super-easy-way-to-make-a-diy-curing-device-with-uv-light-and-heat/17685>\
**Category:** Projects & Prints\
**Created:** [February 28, 2018, 10:08pm UTC](https://forum.formlabs.com/t/super-easy-way-to-make-a-diy-curing-device-with-uv-light-and-heat/17685 "2018-02-28T22:08:14Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![lamaid1](https://avatars.discourse-cdn.com/v4/letter/l/97f17d/32.png) [@lamaid1](https://forum.formlabs.com/u/lamaid1)\
**Post date:** [February 28, 2018, 10:08pm UTC](https://forum.formlabs.com/t/super-easy-way-to-make-a-diy-curing-device-with-uv-light-and-heat/17685/1 "2018-02-28T22:08:14Z")

</div>

Hey guys  
We are an Israeli industrial design office called STUDIOLAMA. We wanted to share the simple process we’ve made. If you have the skills and are looking for an easy way to build your DIY curing device check out how we did it on [this link.](http://studio-lama.com/how-to-make-your-own-diy-curing-device/)

 ![20180228_173306](https://us1.discourse-cdn.com/flex025/uploads/formlabs/original/2X/2/2a8a559abfec0abb1a8a7f4132a64068bc9914cb.jpg)

---

<div class="post-metadata">

**Author:** ![Brandon\_A](https://avatars.discourse-cdn.com/v4/letter/b/74df32/32.png) [@Brandon\_A](https://forum.formlabs.com/u/Brandon_A)\
**Post date:** [February 28, 2018, 11:41pm UTC](https://forum.formlabs.com/t/super-easy-way-to-make-a-diy-curing-device-with-uv-light-and-heat/17685/2 "2018-02-28T23:41:05Z")

</div>

Very cool, though I do have two minor concerns.

1.) Shadowing from part geometry and the oven grate. This could be solved with a clever selection of turntable.  
2.) Safety! You should add a UV blocking layer to the front glass!

Thanks for taking the time to do the write-up!

---

<div class="post-metadata">

**Author:** ![lamaid1](https://avatars.discourse-cdn.com/v4/letter/l/97f17d/32.png) [@lamaid1](https://forum.formlabs.com/u/lamaid1)\
**Post date:** [March 1, 2018, 6:27am UTC](https://forum.formlabs.com/t/super-easy-way-to-make-a-diy-curing-device-with-uv-light-and-heat/17685/3 "2018-03-01T06:27:29Z")

</div>

Thanks for your comment Brandon  
As far as we know UV light at these scales is not dangerous, its similar to sun light but much weaker… Besides that there are 3 types of Uv rays ; A,B and C, only one of them can pass through glass - type A.  
As for the turn table - it might be a good idea but we wanted to keep it simple 🙂