# Sand casting brass/bronze using form2 prints

**URL:** <https://forum.formlabs.com/t/sand-casting-brass-bronze-using-form2-prints/38288>\
**Category:** Projects & Prints\
**Created:** [May 27, 2024, 10:32pm UTC](https://forum.formlabs.com/t/sand-casting-brass-bronze-using-form2-prints/38288 "2024-05-27T22:32:43Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Paraglyphs](https://avatars.discourse-cdn.com/v4/letter/p/5e9695/32.png) [@Paraglyphs](https://forum.formlabs.com/u/Paraglyphs)\
**Post date:** [May 27, 2024, 10:32pm UTC](https://forum.formlabs.com/t/sand-casting-brass-bronze-using-form2-prints/38288/1 "2024-05-27T22:32:43Z")

</div>

Hello, I’ve used my form2 grey resin for RTV molds but am trying sandcasting with higher temp metals. After curing my prints for 8 hours the green sand still sticks to them (even with a healthy dusting of talcum powder) any tips or tricks to get a good release with sand casting from resin prints?

Thx!!

---

<div class="post-metadata">

**Author:** ![system](https://us1.discourse-cdn.com/flex025/uploads/formlabs/original/3X/5/b/5bc2bdf993ff27c2e0eecab5010b25626fbb327a.png) [@system](https://forum.formlabs.com/u/system)\
**Post date:** [November 26, 2024, 10:33am UTC](https://forum.formlabs.com/t/sand-casting-brass-bronze-using-form2-prints/38288/2 "2024-11-26T10:33:17Z")

</div>

Closed on November 26, 2024, 10:33am UTC

This topic was automatically closed 182 days after the last reply. New replies are no longer allowed.