# Resin to approximate the look of stone?

**URL:** <https://forum.formlabs.com/t/resin-to-approximate-the-look-of-stone/29673>\
**Category:** Experimental\
**Created:** [December 21, 2020, 5:46pm UTC](https://forum.formlabs.com/t/resin-to-approximate-the-look-of-stone/29673 "2020-12-21T17:46:07Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![RedAccordion](https://sea1.discourse-cdn.com/flex025/user_avatar/forum.formlabs.com/redaccordion/32/15778_2.png) [@RedAccordion](https://forum.formlabs.com/u/RedAccordion)\
**Post date:** [December 21, 2020, 5:46pm UTC](https://forum.formlabs.com/t/resin-to-approximate-the-look-of-stone/29673/1 "2020-12-21T17:46:07Z")

</div>

I guess this isn’t necessarily experimental, but I am trying to decide between using standard white or the Ridged 10K I was gifted, to print a pair of figurines to look stone-ish (white marble perhaps?).

I realize the 10K is NOT geared towards sculptural/art/design, but from what I hear it has a nice surface quality and at least the figurines would be less breakable than the white.

Looking for thoughts on the matter. I would love to be able to shine the piece some, as well. I do not want to use a spray varnish. Thought about epoxy coating, but the surface tension on that stuff always leaves places it didn’t coat.

Thanks!

---

<div class="post-metadata">

**Author:** ![rkagerer](https://avatars.discourse-cdn.com/v4/letter/r/439d5e/32.png) [@rkagerer](https://forum.formlabs.com/u/rkagerer)\
**Post date:** [December 21, 2020, 11:56pm UTC](https://forum.formlabs.com/t/resin-to-approximate-the-look-of-stone/29673/2 "2020-12-21T23:56:33Z")

</div>

I think Rigid will look more “stone-like” before finishing than plain White. Note after sanding Rigid (at least, 4K) gets a smooth sheen to it which does look very much like polished plastic.

---

<div class="post-metadata">

**Author:** ![RedAccordion](https://sea1.discourse-cdn.com/flex025/user_avatar/forum.formlabs.com/redaccordion/32/15778_2.png) [@RedAccordion](https://forum.formlabs.com/u/RedAccordion)\
**Post date:** [December 22, 2020, 2:34pm UTC](https://forum.formlabs.com/t/resin-to-approximate-the-look-of-stone/29673/3 "2020-12-22T14:34:20Z")

</div>

Thanks. I chickened out and went with gray (turns out I’m out of white). Just going to prime and paint.

I read that Rigid 10K is “powdery”, which I gathered means chalky or imparts powder on the user’s hand? Not sure. Looking for an excuse to use it however. Thinking maybe a mold for silicone rubber castings…
