# Resin tank none, Form 2 doesn't recognize the resin tank **URL:** \ **Category:** Form 2\ **Created:** [October 14, 2019, 2:40pm UTC](https://forum.formlabs.com/t/resin-tank-none-form-2-doesnt-recognize-the-resin-tank/24983 "2019-10-14T14:40:23Z")\ **Posts on this page:** 1\ **Showing post:** 4
**Author:** ![eaelec](https://avatars.discourse-cdn.com/v4/letter/e/13edae/32.png) [@eaelec](https://forum.formlabs.com/u/eaelec)\ **Post date:** [October 14, 2019, 11:49pm UTC](https://forum.formlabs.com/t/resin-tank-none-form-2-doesnt-recognize-the-resin-tank/24983/4 "2019-10-14T23:49:51Z")
It could be that the plug on the bottom of the carrier plate has become unseated. You don’t want to remove the carrier plate if your unit is still under warranty, but if it’s not, you should read this thread all the way through before removing the plate or you may not be able to get the plate levelled: > [@This is definitely going to void your warranty](http://forum.formlabs.com/t/this-is-definitely-going-to-void-your-warranty/24248): > > The resin tank contacts on the carrier plate of my Form 2 had been gradually failing. It got so bad that just closing the lid on the printer would cause it to lose contact with the tank. Then I would have to pull out and re-insert the tank numerous times until contact was restored. Then one day it failed and no amount of pushing and pulling could fix the problem. So … Top of Carrier Plate --- _[View the full topic](https://forum.formlabs.com/t/resin-tank-none-form-2-doesnt-recognize-the-resin-tank/24983)._