# Repeatably Printing **URL:** \ **Category:** Support & Troubleshooting\ **Created:** [April 17, 2019, 7:00pm UTC](https://forum.formlabs.com/t/repeatably-printing/23105 "2019-04-17T19:00:25Z")\ **Posts on this page:** 4\ **Page:** 1
**Author:** ![tgatliff](https://avatars.discourse-cdn.com/v4/letter/t/278dde/32.png) [@tgatliff](https://forum.formlabs.com/u/tgatliff)\ **Post date:** [April 17, 2019, 7:00pm UTC](https://forum.formlabs.com/t/repeatably-printing/23105/1 "2019-04-17T19:00:25Z")
Whenever I re-run jobs, I have to move the part around so that it doesnt glaze a particular area. Is there an easier way to do this? Would be nice if the printer could do this automatically… Thoughts? ---
**Author:** ![JohnHue](https://avatars.discourse-cdn.com/v4/letter/j/48db29/32.png) [@JohnHue](https://forum.formlabs.com/u/JohnHue)\ **Post date:** [April 18, 2019, 7:32am UTC](https://forum.formlabs.com/t/repeatably-printing/23105/2 "2019-04-18T07:32:01Z")
Buy an LT tank, problem solved 😉 ---
**Author:** ![tgatliff](https://avatars.discourse-cdn.com/v4/letter/t/278dde/32.png) [@tgatliff](https://forum.formlabs.com/u/tgatliff)\ **Post date:** [April 18, 2019, 3:01pm UTC](https://forum.formlabs.com/t/repeatably-printing/23105/3 "2019-04-18T15:01:48Z")
I own allot of LT tanks, and have mixed feelings on this. They also will glaze over repeated uses in the same spot, but I admit that it takes longer. The biggest frustration I have with them, however, is when the inevitable failed job occurs, you have to be extremely careful not to damage the layer. In some cases, you simply cannot get the stuck material off without causing some sort of damage to it. The standard tanks, however, rarely get damaged this way. ---
**Author:** ![system](https://us1.discourse-cdn.com/flex025/uploads/formlabs/original/3X/5/b/5bc2bdf993ff27c2e0eecab5010b25626fbb327a.png) [@system](https://forum.formlabs.com/u/system)\ **Post date:** [May 2, 2019, 3:02pm UTC](https://forum.formlabs.com/t/repeatably-printing/23105/4 "2019-05-02T15:02:01Z")
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.