Print orientation for clear visors

Hi Guys,

Any reason why you would suggest not printing these components in this image??

These are supposed to be wind shields for a model car - and would prefer to not have supports on them…

Thanks

Ed

Looks good. I’d print them so that the long axis goes from the left to the right of the printer (e.g. looking from the front you’ll see the face of the windshield). This will allow resin to better flow around the part during the peel cycle. My experience has shown that 50 micron layer thickness yields the best optical properties.

2 Likes

Thanks for the prompt reply - guess i’ll go buy some clear resin! :wink: