# Open Material Print Settings

**URL:** <https://forum.formlabs.com/t/open-material-print-settings/45415>\
**Category:** Form 4/B/L\
**Created:** [September 15, 2025, 9:34pm UTC](https://forum.formlabs.com/t/open-material-print-settings/45415 "2025-09-15T21:34:12Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![jguthrie](https://avatars.discourse-cdn.com/v4/letter/j/f08c70/32.png) [@jguthrie](https://forum.formlabs.com/u/jguthrie)\
**Post date:** [September 15, 2025, 9:34pm UTC](https://forum.formlabs.com/t/open-material-print-settings/45415/1 "2025-09-15T21:34:12Z")

</div>

Has anyone come up with a goo sequence of tests and parts to print to dial in open material settings?

---

<div class="post-metadata">

**Author:** ![MattRForerunner](https://sea1.discourse-cdn.com/flex025/user_avatar/forum.formlabs.com/mattrforerunner/32/20355_2.png) [@MattRForerunner](https://forum.formlabs.com/u/MattRForerunner)\
**Post date:** [September 16, 2025, 1:29pm UTC](https://forum.formlabs.com/t/open-material-print-settings/45415/2 "2025-09-16T13:29:04Z")

</div>

find a formlabs equivalent material and start from there making adjustments until you reach the similar properties of the resin you are using.

---

<div class="post-metadata">

**Author:** ![jguthrie](https://avatars.discourse-cdn.com/v4/letter/j/f08c70/32.png) [@jguthrie](https://forum.formlabs.com/u/jguthrie)\
**Post date:** [September 16, 2025, 3:50pm UTC](https://forum.formlabs.com/t/open-material-print-settings/45415/3 "2025-09-16T15:50:30Z")

</div>

I have done that. I am more concerned with the workflow since there are a lot of settings to be adjusted. I dialed in my size correction factors and now I’m messing with different exposures, but I think there should be a more specific workflow to follow. Should offset, correction factor, or exposures be dialed in first? And what parts can you print to achieve this and measure and correct the settings?

---

<div class="post-metadata">

**Author:** ![leonhart88](https://sea1.discourse-cdn.com/flex025/user_avatar/forum.formlabs.com/leonhart88/32/19153_2.png) [@leonhart88](https://forum.formlabs.com/u/leonhart88)\
**Post date:** [September 16, 2025, 10:10pm UTC](https://forum.formlabs.com/t/open-material-print-settings/45415/4 "2025-09-16T22:10:00Z")

</div>

I agree, the available knowledge out there is extremely limited. I’m going to go through this process myself soon…will probably document what I find along the way so the knowledge is shared.